XYR5000 Differential Pressure Transmitter

The WD520 is part of the XYR 5000 family of
wireless products. These transmitters cover a wide
differential pressure range, and can be used to
monitor a variety of processes and assets in
hazardous and remote areas.
The WD520 can be set to
operate in four modes: differential pressure,
orifice flow, open channel flow, and level. Since
there are no wires to run, the transmitter can be
installed and operational in minutes, quickly
providing information about the variable being
monitored.
The Smart Response Manager allows the
transmitter to adapt to changing process conditions,
allowing greater visibility to process variation.
Smart Response Manager allows the user to set
thresholds which, when exceeded, cause the
transmitter to adjust sampling and data transmission
rates.
The transmitter combines a differential pressure
sensor with a Radio Frequency (RF) transceiver that
communicates in a digital protocol, using Frequency
Hopping Spread Spectrum (FHSS). FHSS ensures data
integrity by continually switching the carrier wave
over a wide range of frequencies. Power is supplied
by a C size 3.6 V lithium battery, with an expected
lifetime of up to five years
Features
-
Five most common ranges of differential pressure transmitters from
100” H2O to 300 psid are available for application.
- WD520 : -100 to 100 “ H2O @ 68°F
- WD521 : -300 to 300 “ H2O @ 68°F
- WD522 : -25 to 25 PSID
- WD523 : -25 to 100 PSID
- WD524 : -25 to 300 PSID
-
Integrated LCD display with membrane switch buttons for local
configuration.
-
LCD display is 7-digit (alternating) high contrast, anti-reflective
monochrome.
-
Contains the following selectable engineering units ATMS, BAR, FT
H2O, GM/SQCM, IN HG, IN H2O, INH2O4C, KG/SQCM, KPASCAL, MPASCAL,
MBAR, MM HG, MM H20, MMH2O4C, PASCALS, PER FS, PSI, SPECIAL.